Are you guys looking for Computer science Engineering MCQ Questions with Answers PDF Free Download as per Computer science Engineering new exam pattern? You came to the right page. This may assist you to understand and check your knowledge about the Subjects. Students also can take a free test of the Multiple Choice Questions of Computer science Engineering. Each question has four options followed by the right answer. These Computer science Engineering MCQ Questions are selected supported by the newest exam pattern.
Q1. Which of the following files is used for NetBIOS name resolution?
(A) HOSTS
(B) LMHOSTS
(C) ARP
(D) FQDN
Answer:(B) LMHOSTS
Q2. What is the standard protocol for network management features?
(A) SNA
(B) FTP
(C) SNMP
(D) SMS
Answer: (C) SNMP
Q3. What can cause a problem with communication with a client by name but not by IP address?
(A) The IP address
(B) Static files such as an LMHOSTS file or a DNS database
(C) Subnet mask
(D) The default gateway
Answer: (B) Static files such as an LMHOSTS file or a DNS database
Q4. In CRC the quotient at the sender
(A) Becomes the dividend at the receiver
(B) Becomes the divisor at the receiver
(C) Is discarded
(D) Is the remainder
Answer:(C) Is discarded
Q5. The data-link layer, in reference to the OSI model, specifies
(A) Data link procedures that provide for the exchange of data via frames that can be sent and received
(B) The interface between the X.25 network and packet mode device
(C) The virtual circuit interface to packet-switched service
(D) None of the above
Answer: (A) Data link procedures that provide for the exchange of data via frames that can be sent and received
Q6. Which of the following items is not used in Local Area Networks (LANs)?
(A) Computer
(B) Modem
(C) Printer
(D) Cable
Answer: (B) Modem
Q7. Which of the following best describes the scopes on each DHCP server, in the absence of configuration problems with DHCP addresses, if you use multiple DHCP servers in your environment?
(A) Unique to that subnet only
(B) For different subnets
(C) For no more than two subnets
(D) For no subnets
Answer: (B) For different subnets
Q8. Packet Switch Stream (PSS) was introduced in
(A) The US in 1961 (&) the UK in 1981
(B) The UK in 1980
(C) The US in 1961
(D) None of the above
Answer: (B) The UK in 1980
Q9. You are working with a class C network. You are required to configure it for five subnets, each of which will support 25 nodes. What subnet should you use?
(A) 255.255.255.0
(B) 255.255.255.224
(C) 255.255.255.240
(D) 255.255.255.248
Answer: (B) 255.255.255.224
Q10. Error detection at the data link level is achieved by?
(A) Bit stuffing
(B) Hamming codes
(C) Cyclic Redundancy codes
(D) Equalization
Answer: (C) Cyclic Redundancy codes
Q11. Which of the following divides the high speed signal into frequency bands?
(A) t-switch
(B) Modem
(C) Frequency-division multiplexer
(D) Time-division multiplexer
Answer: (C) Frequency-division multiplexer
Q12. The slowest transmission speeds are those of
(A) Twisted-pair wire
(B) Coaxial cable
(C) Fiber-optic cable
(D) Microwaves
Answer: (A) Twisted-pair wire
Q13. The physical layer, in reference to the OSI model, defines
(A) Data link procedures that provide for the exchange of data via frames that can be sent and received
(B) The interface between the X.25 network and packet mode device
(C) The virtual circuit interface to packet-switched service
(D) All of the above
Answer: (B) The interface between the X.25 network and packet mode device
Q14. Thorough planning must take place when setting up an 802.3 network. A maximum number of segments can separate any two nodes on the network. What is the maximum number of segments allowed between two nodes?
(A) Five
(B) Two
(C) Four
(D) Six
Answer: (A) Five
Q15. Because the configuration information for a DHCP client is received dynamically, you must use which utility to read the current configuration to verify the settings?
(A) PING
(B) TRACERT
(C) ARP
(D) IPCONFIG
Answer: (D) IPCONFIG
Networking MCQ – All Set
- Networking Exam Preparation Questions and Answers – Set 01
- What is Network and Internet Questions and Answers – Set 02
- Uses of Computer Network MCQ Test – Set 03
- Types of Computer Networks Objective Questions – Set 04
- Online Test Characteristics of Computer Network – Set 05
- Networking Computer Science Basic Questions – Set 06
- Networking Engineering Interview Questions – Set 07
- Computer Networking Quiz Questions & Answers – Set 08
- Networking Exam Preparation Online Test – Set 09
- Multiple Choice Test Networking – Set 10
- Networking Computer Science Questions and Answers – Set 11
- Computer Science Engineering Networking MCQ – Set 12
- Computer Networking Interview Guide – Set 13
- Computer Science Networking Jobs Questions – Set 14
- Computer Science Networking MCQs – Set 15
- Computer Science Networking Questions – Set 16
- Computer Science Networking Degree Questions – Set 17
- Computer Science Networking and Internet Architecture – Set 18
- Computer Science and Networking Questions & Answers – Set 19
- Computer Science Networking Basics MCQs – Set 20
- Computer Science Computer Networking Questions – Set 21
- Networking in Computer Science Engineering MCQs – Set 22
- Networking for Computer Science pdf – Set 23
- Networking Computer Science Skills Questions – Set 24
- Computer Science with Networking Test – Set 25
- Fields in Computer Science Networking Practice Test – Set 26
- Computer Science Networking Guide – Set 27
- Gate Computer Science Networking Test – Set 28
- Computer Networking Multiple Choice Questions Set – 29
We hope the given computer science Engineering on Networking MCQ Questions with Answers will definitely yield fruitful results. Hope you got enough ideas on the MCQs on Networking. If you have any queries related to computer science Engineering on Networking MCQs Multiple Choice Questions with Answers, drop your questions below and will get back to you as soon as possible.