Computer Networking Quiz Set – 29 :: Computer Science Engineering

Are you guys looking for Computer science Engineering MCQ Questions with Answers PDF Free Download as per Computer science Engineering new exam pattern? You came to the right page. This may assist you to understand and check your knowledge about the Subjects. Students also can take a free test of the Multiple Choice Questions of Computer science Engineering. Each question has four options followed by the right answer. These Computer science Engineering MCQ Questions are selected supported by the newest exam pattern.


Q1. The most important part of a multiple DHCP configurations is to make sure you don’t have which of the following in the different scopes? Select the best answer.

(A) Duplicate addresses
(B) Duplicate pools
(C) Duplicate subnets
(D) Duplicate default gateways

Answer: (A) Duplicate addresses


Q2. Information systems with common hardware, software, and network standards that provide easy access for end users and their networked computer systems. Select the best fit for answer:

(A) TCP/IP
(B) Protocol
(C) Open Systems
(D) Internetwork processor

Answer: (C) Open Systems


Q3. The amount of uncertainty in a system of symbol is called

(A) Bandwidth
(B) Entropy
(C) Loss
(D) Quantum

Answer: (B) Entropy


Q4. An example of an analog communication method is

(A) Laser beam
(B) Microwave
(C) Voice grade telephone line
(D) All of the above

Answer:(D) All of the above


Q5. Compared to analog signals, digital signals

(A) Allow faster transmission
(B) Are more accurate
(C) Both (a) and (b)
(D) All of the above

Answer: (C) Both (a) and (b)


Q6. A WATS arrangement

(A) Is always less expensive than flat-rate service
(B) Is less expensive than flat-rate service only when the number of calls is large and the duration of each is short
(C) Is less expensive than flat-rate service only when the number of calls is small and the duration of each is long
(D) Is never less expensive than flat-rate service

Answer: (B) Is less expensive than flat-rate service only when the number of calls is large and the duration of each is short


Q7. Error rate is

(A) An error-detecting code based on a summation operation performed on the bits to be checked
(B) A check bit appended to an array of binary digits to make the sum of all the binary digits
(C) A code in which each expression conforms to specific rules of construction, so that if certain errors occur in an expression, the resulting expression will not conform to the rules of construction and thus the presence of the errors is detected
(D) The ratio of the number of data units in error to the total number of data units

Answer: (D) The ratio of the number of data units in error to the total number of data units


Q8. What OSI layer handles logical address to logical name resolution?

(A) Transport
(B) Physical
(C) Presentation
(D) Data Link

Answer: (A) Transport


Q9. Which of the following statements is incorrect?

(A) The difference between synchronous and asynchronous transmission is the clocking derived from the data in synchronous transmission
(B) Half-duplex line is a communication line in which data can move in two directions, but not at the same time
(C) Teleprocessing combines telecommunications and DP techniques in online activities
(D) Batch processing is the preferred processing mode for telecommunication operations

Answer:(D) Batch processing is the preferred processing mode for telecommunication operations


Q10. Four routers have to be interconnected in a point-to-point Network. Each pair of root us may connected by a high-speed line, a medium speed line or a low speed line. Find the total number of topologies.

(A) 12
(B) 81
(C) 48
(D) 729

Answer: (D) 729


Q11. What frequency range is used for microwave communications, satellite and radar?

(A) Low Frequency : 30 kHz to 300 kHz
(B) Medium Frequency : 300 kHz to 3 MHz
(C) Super High Frequency : 3000 MHz to 30000 MHz
(D) Extremely High Frequency : 30,000 MHz

Answer:(D) Extremely High Frequency : 30,000 MHz


Q12. The systematic access of small computers in a distributed data processing system is referred to as:

(A) Dialed service
(B) Multiplexing
(C) Polling
(D) Conversational mode

Answer: (C) Polling


Q13. An example of digital, rather than analog, communication is

(A) DDD
(B) DDS
(C) WATS
(D) DDT

Answer: (B) DDS


Q14. A communications device that combines transmissions from several 1/ O devices into one line is a:

(A) Concentrator
(B) Modifier
(C) Multiplexer
(D) Full-duplex line

Answer: (C) Multiplexer


Q15. Which of the following layer protocols are responsible for user and the application program support such as passwords, resource sharing, file transfer and network management?

(A) Layer 7 protocols
(B) Layer 6 protocols
(C) Layer 5 protocols
(D) Layer 4 protocols

Answer: (A) Layer 7 protocols


Networking MCQ – All Set

We hope the given computer science Engineering on Networking MCQ Questions with Answers will definitely yield fruitful results. Hope you got enough ideas on the MCQs on Networking. If you have any queries related to computer science Engineering on Networking MCQs Multiple Choice Questions with Answers, drop your questions below and will get back to you as soon as possible.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top