Are you guys looking for Civil Engineering MCQ Questions with Answers PDF Free Download as per Civil Engineering new exam pattern? You came to the right page. This may assist you to understand and check your knowledge about the Subjects. Students also can take a free test of the Multiple Choice Questions of Civil Engineering. Each question has four options followed by the right answer. These Civil Engineering MCQ Questions are selected supported by the newest exam pattern.

## Q1. The centre of gravity of a triangle is at the point where three

(A) Medians of the triangle meet

(B) Perpendicular bisectors of the sides of the triangle meet

(C) Bisectors of the angle of the triangle meet

(D) None of these

Answer: (A) Medians of the triangle meet

## Q2. A ball which is thrown upwards, returns to the ground describing a parabolic path during its flight

(A) Vertical component of velocity remains constant

(B) Horizontal component of velocity remains constant

(C) Speed of the ball remains constant

(D) Kinetic energy of the ball remains constant

Answer: (B) Horizontal component of velocity remains constant

## Q3. A simple pendulum of length / has an energy E, when its amplitude is A. If the length of pendulum is doubled, the energy will be

(A) E

(B) E/2

(C) 2E

(D) 4E

Answer: (B) E/2

## Q4. For perfectly elastic bodies, the value of coefficient of restitution is

(A) Zero

(B) 0.5

(C) 1.0

(D) Between 0 and 1

Answer: (C) 1.0

## Q5. A string of length 90 cm is fastened to two points ‘A’ and ‘B’ at the same level 60 cm apart. A ring weighing 120 g is slided on the string. A horizontal force ‘P’ is applied to the ring such that it is in equilibrium vertically below ‘B’. The value of ‘P’ is:

(A) 40 g

(B) 60 g

(C) 80 g

(D) 100 g

Answer: (C) 80 g

## Q6. A particle moving with a simple harmonic motion, attains its maximum velocity when it passes

(A) The extreme point of the oscillation

(B) Through the mean position

(C) Through a point at half amplitude

(D) None of these

Answer: (B) Through the mean position

## Q7. A stone was thrown vertically upwards from the ground with a velocity of 50 m/sec. After 5 seconds another stone was thrown vertically upwards from the same place. If both the stones strike the ground at the same time, then the velocity with which the second stone was thrown should be (Assume g = 10 m/sec²)

(A) 15 m/sec

(B) 25 m/sec

(C) 40 m/sec

(D) 50 m/sec

Answer: (B) 25 m/sec

## Q8. A satellite is said to move in a synchronous orbit if it moves at an altitude of 36,000 km with a maximum velocity of about

(A) 7000 km per hour

(B) 8000 km per hour

(C) 9000 km per hour

(D) 11,000 km per hour

Answer: (D) 11,000 km per hour

## Q9. Pick up the correct statement from the following:

(A) Nature plays an important role in the launch of a satellite

(B) The earth’s gravity reduces the speed of a satellite by 32 km per second

(C) The gravitational force relents as the satellite climbs higher

(D) All the above

Answer: (D) All the above

## Q10. A retarding force on a body does not

(A) Change the motion of the body

(B) Retard the motion of the body

(C) Introduce the motion of the body

(D) None of these

Answer: (B) Retard the motion of the body

## Q11. A rigid body is in a stable equilibrium if the application of any force

(A) Can raise the CG of the body but cannot lower it

(B) Tends to lower the CG of the body

(C) Neither raises nor lowers the CG of the body

(D) None of above

Answer: (A) Can raise the CG of the body but cannot lower it

## Q12. A stone of mass 1 kg is tied to a string of length 1 m and whirled in a horizontal circle at a constant angular speed 5 rad/sec. The tension in the string is,

(A) 5 N

(B) 10 N

(C) 15 N

(D) 25 N

Answer: (D) 25 N

## Q13. A cable loaded with 0.5 tonne per horizontal metre span is stretched between supports in the same horizontal line 400 m apart. If central dip is 20 m, the minimum tension in the cable, will be

(A) 200 tonnes at the centre

(B) 500 tonnes at the centre

(C) 200 tonnes at the right support

(D) 200 tonnes at the left support

Answer: (B) 500 tonnes at the centre

## Q14. The reaction at the support B of the beam shown in below figure is

Applied Mechanics set 5 ques 10

(A) 1.6 t

(B) 9.6 t

(C) 8.5 t

(D) 0.5 t

Answer: (C) 8.5 t

## Q15. A ladder of weight ‘w’ rests against a smooth vertical wall, and rests on rough horizontal ground, the coefficient of friction between the ladder and the ground being 1/4. The maximum angle of inclination of the ladder to the vertical, if a man of weight ‘w’ is to walk to the top of it safely, is tan’1 x, where x is

(A) 1/4

(B) 1/3

(C) 3

(D) 4

Answer: (B) 1/3

## Applied Mechanics and Graphic Statics MCQ with Answers

**Applied Mechanics and Graphic Statics MCQ Test – Set 01****Applied Mechanics Objective Test – Set 02****Applied Mechanics Questions and Answers – Set 03****Applied Mechanics Objective Questions – Set 04****Applied Mechanics MCQ Test – Set 05****Applied Mechanics and Graphic Statics MCQ Practice – Set 06****Graphic Statics Exam Practice – Set 07****Applied Mechanics MCQ Exam Questions – Set 08****Objective Type Questions on Applied Mechanics – Set 09****Applied Mechanics and Graphic Statics MCQ – Set 10****Online Study Materials on Applied Mechanics – Set 11****Online Study Materials on Graphic Statics – Set 12****Multiple Choice Questions Civil Applied Mechanics – Set 13****MCQ Test Applied Mechanics and Graphic Statics – Set 14****Civil Engineering Applied Mechanics MCQ – Set 15****Civil Engineering Graphic Statics MCQ – Set 16****Theory Practice Applied Mechanics and Graphic Statics – Set 17****Applied Mechanics and Graphic Statics – Set 18****Objective Test Applied Mechanics and Graphic Statics – Set 19****Online Test Civil Applied Mechanics and Graphic Statics – Set 20****Civil Graphic Statics MCQ Quiz Questions – Set 21****Online Quiz Test Applied Mechanics and Graphic Statics – Set 22****Civil Engineering Applied Mechanics Quiz – Set 23****Applied Mechanics and Graphic Statics Online Exam set 24**

We hope the given **Applied Mechanics and Graphic Statics MCQ Questions with Answers** on Civil Engineering will definitely yield fruitful results. Hope you got enough ideas on the **Applied Mechanics and Graphic Statics MCQs** on Civil Engineering. If you have any queries related to Civil Engineering MCQs Multiple Choice Questions with Answers, drop your questions below and will get back to you in no time.